Roulette relabel - Seating chips, meet up chips, what else? (1 Viewer)

[GreekRedEye]

EDITED to shorten.

I have a bunch of roulette mold chips. I am thinking of relabeling one side only to use as seating chips.

What do you all think? Anyone interested in a set?

Suggestions welcome.

This is the main stash:

I can make 2 sets of flamingos, I even have a run of 1 to 7 numbers in the yellow.

I can build 2 sets of President-Casino

I am one chip away from a Sundowner set

Harrah's house mold, anyone?

These guys will not be part of the project except for the Isle of Capri inlaid roulettes.

No idea what to do with these. Any ideas?

Tagging a few folks that I think might be interested in this project: @UniLover @sleepypiggly @Okku @Colquhoun @ekricket

 

[allforcharity]

STFU











(I meant as a chip, not a command.)

 

[GreekRedEye]

Message received (I think). I edited the first post to make it short and to the point.

 

[moose]

Some of those bright colours would be good for bomb pot chips

 

[Colquhoun]

Inlaid chips don’t need to be milled, they should be over-labeled or murdered (inlay removal). There’s some good threads on here, never done it myself.
Hotstamps need to be milled. I’ve done it, but you need a drill press, an appropriate clean-out bit, and some form of jig to hold it.

Nice endeavor, seating chips seem popular. You could also do show-em, rebuy, bounty, etc.

 

[GreekRedEye]

Inlaid chips don’t need to be milled, they should be over-labeled or murdered (inlay removal). There’s some good threads on here, never done it myself.
Hotstamps need to be milled. I’ve done it, but you need a drill press, an appropriate clean-out bit, and some form of jig to hold it.

Nice endeavor, seating chips seem popular. You could also do show-em, rebuy, bounty, etc.

I am sticking to inlays in this project, I think. I will not have access to my tools for a while.

STFU as a chip

Some of those bright colours would be good for bomb pot chips

You could also do show-em, rebuy, bounty, etc.

Some good ideas.

What do you all think about leaving one original label on one side?

 

[moose]

I always like knowing the original source of the chips, as long as it doesn't create confusion.

 

[GreekRedEye]

Some of the amazing roulettes I have deserve a custom label to match the casino, but I'm starting with a generic design for seating that I can use with about half the chips - to save on label printing costs. I will add bomb pot, show em, etc designs later.

Maybe it is the cold I am fighting, but my initial design might be the most boring in the history of PCF. Please help me improve it while keeping it generic enough to work with a variety of chips.

I am going to start with sluggo relabels before graduating to Paulsons and ASMs.
(By the way, if anyone uses these chips and wants them, I have 1 barrel in black, pink, and blue)

Mocked up. The sluggos will get 2 sides labeled, so I could make the obverse the same or "All In" or "Bounty" or other.

 

[allforcharity]

You can skip the "Table A" part if you just use a different background design and/or colour (for each set).