I mocked these up on Photoshop over the weekend.
I did them in the style of clay chips, but I am going to buy them as ceramic, since custom ceramic is like 1/5 of the cost of custom clay.
I went with a different pattern on the rim so I wouldn’t have to pay the extra amount for aligned edge spots.
The 5, 25, 100, and 500 are 39mm. The 1000 is 43mm and the dealer button is 60mm.
I was worried about the purple being too dark and that would cause dirty stacks with the 100s, but I think this will be ok, as long as the black doesn’t show up as dark gray when they are printed.
These are very close to “print ready” but I want them to be as close to perfect as possible if I am going to spend so much money on them.
What do you think? Advice and critique welcome.
I did them in the style of clay chips, but I am going to buy them as ceramic, since custom ceramic is like 1/5 of the cost of custom clay.
I went with a different pattern on the rim so I wouldn’t have to pay the extra amount for aligned edge spots.
The 5, 25, 100, and 500 are 39mm. The 1000 is 43mm and the dealer button is 60mm.
I was worried about the purple being too dark and that would cause dirty stacks with the 100s, but I think this will be ok, as long as the black doesn’t show up as dark gray when they are printed.
These are very close to “print ready” but I want them to be as close to perfect as possible if I am going to spend so much money on them.
What do you think? Advice and critique welcome.