Wide Rcks (1 Viewer)

[MikesDad]

I have som CPC SCROWNS that were used for hotstamps. The stamping process appears to have made the chips "wider" around
the edges to the point that they don't fit in the normally sized racks. I can force them to fit in Matsui racks (which I really don't want to do),
but even then the top of the Matsui racks won't fit over the chips.

Using a caliper, the width of a barrel measures just over 72mm.

Does anyone know of racks that are this wide?

Thanks

 

[kaimat]

Have you tried scraping the hotstamps to remove the excess foil?

 

[ekricket]

You may need to go through the flattening process for them.

 

[FestiveKnight]

Matsui racks are usually the best I have found for CPCs but they don't work for all barrels. There are weird racks out there that fit these types of chips better but nont common ones I have found, all the regular rack producers don't seem able to produce a rack literally 2mm wider.....

 

[MikesDad]

Have you tried scraping the hotstamps to remove the excess foil?

SCrowns are concave, so I don't think the foil is the issue

 

[MikesDad]

Have you tried scraping the hotstamps to remove the excess foil?

Maybe so...

 

[GreekRedEye]

72mm is pretty wide. I hunted for some wider racks and found the Davincis worked for me. But they are not 72mm.
https://www.pokerchipforum.com/threads/poker-racks-2023.110030/post-2290240

You might need to custom 3d print something.

 

[Josh Kifer]

SCrowns are concave, so I don't think the foil is the issue

It's flashing due to needing to push in deeper because SCrowns are concave. It can be scraped, or some heavy play or shuffling will wear those edges down. In my hot stamp FAQ has a section on it.

 

[MikesDad]

72mm is pretty wide. I hunted for some wider racks and found the Davincis worked for me. But they are not 72mm.
https://www.pokerchipforum.com/threads/poker-racks-2023.110030/post-2290240

You might need to custom 3d print something.

This is the way