Design notes:
* These are waterproof vinyl label-overs, printed on full sheets and cut with a hole punch.
* I worked with the edgespot and base color to create two distinct but coordinating A-through-10 (T) runs.
* The flipsides say “all in,” to be used as such and also to double as bounty chips.
* The punch I have is getting a little dull, even after trying the tinfoil sharpening trick... As a result, there are some flaws. I may buy another punch and redo a few of these.
* The diameter of the punch is very, very close to that of the interior mold, so if not perfectly aligned I got some ride-ups along the edges. So again, I’ll have to redo a few of these.
* On the 6 and 9 chips, I put a small underscore at the bottom of each numeral fo show the correct orientation.
* Previously I used red Royal blanks to fit in with the 43mm Jacks and faux-jacks in the tourney set... These turned out great, except that the edgespots on those and the Jack 1K secondaries was too close. I also tried Sunset Beach got pinks, but some color clash issues arose.
* I think I’m finally settled now on these... Besides quality-controlling the labels, the only light issue left is that in low light their lilac color and the grey 5Ks cam converge a bit. But the edgespots and labels should distinguish them enough.