Blasphemy
New Member
Hello all, poker chip newbie who has been lurking for a bit...
A couple months ago I bought a set of fairly cheap poker chips from discountpokershop, the Z-Pro Clay Chips for board gaming. I recently noticed that every single one of my 100 and 500 denomination chips have labels that are just slightly too big for the chip inlays. As such, they all have one edge of the label resting on top of the edge of the inlay. Is there any good way of trimming these down a bit, or should I look into doing a complete relabel? I'm not especially opposed to doing a relabel since I'm also looking into relabeling some 1000, 5000, and 10000 chips into 2, 10, and possibly 20. It would be nice if I could salvage the original labels though, as I have every intention of going fairly cheap on any relabeling I decide to do.
A couple months ago I bought a set of fairly cheap poker chips from discountpokershop, the Z-Pro Clay Chips for board gaming. I recently noticed that every single one of my 100 and 500 denomination chips have labels that are just slightly too big for the chip inlays. As such, they all have one edge of the label resting on top of the edge of the inlay. Is there any good way of trimming these down a bit, or should I look into doing a complete relabel? I'm not especially opposed to doing a relabel since I'm also looking into relabeling some 1000, 5000, and 10000 chips into 2, 10, and possibly 20. It would be nice if I could salvage the original labels though, as I have every intention of going fairly cheap on any relabeling I decide to do.