Looking for help designing "realistic" chip edges (2 Viewers)

[stubidet]

Hello,

I am in the process of designing a set of chips for an alibaba purchase and I would like the edges of the chips to look like the above (i.e. imitating the look of compressed chips). I am struggling to search relevant information (I'm sure this has been covered before!) as I don't know what these lines on the edges of chips are actually called! For my design (screenshot below) I have used a template that I found on this forum which has straight lines, would anyone know if there are templates with the "realistic"/"compression" lines already out there or is this something I should draw in AI myself?

Thank you very much in advance for your help with this, would definitely not have come anywhere near as far with this project without the help of people on this forum!

 

[stubidet]

Would be amazing if any users had 4d14 and 4ta181418 templates with the compression lines (/realistic lines?) to share, as I'm not that confident in my ability to get the lines right drawing them freehand in AI.

 

[Colquhoun]

I made a post about it a while back. Basically I do them all by hand. I’ll look and see if I have some already done that match the chips you’re looking for.
If you want to take a stab at it, here’s how I do it:
https://www.pokerchipforum.com/threads/messing-around-with-inkscape.102525/page-2#post-2268264

I use the same process for the rolling edge.

 

[Colquhoun]

PM sent.