buffalojim
Royal Flush
Pretty sure the obvious answer here is Edging, just don't toss that shit in Google.
I did warn you.Anyone else immediately google it?
When are you going to start taking commissions?
Also, I feel like your process needs a name... scalping?
if we are coming up with names that will cause confusion when googling, we should definitely call it rimming.Pretty sure the obvious answer here is Edging, just don't toss that shit in Google.
Rim job works too. Ok, I'll see myself out.if we are coming up with names that will cause confusion when googling, we should definitely call it rimming.
10% - he keeps two chips out of every barrel you send him.How much do you charge for this process?
Rim job works too. Ok, I'll see myself out.
You are bad. I like you.Don’t forget to put it through the cleveland steamer with a little tsp.
Well that fits well with “murdered”Pretty sure the obvious answer here is Edging, just don't toss that shit in Google.
Photos didn’t load?Client #1 results
Stage 1 Conditioned: From no stand on edge to about 30% Stand on edge. little noticeable size change in mixed stack.
Original Condition 1-10 was a 5+/- End Condition 6 - 6.5
Stage 2 Conditioning: Still Flea bites but reduced sizes and sharper edges. Mixed stack, small variation to untouched and can be minimally felt. All conditioned chips are the same size as the equipment assures that.
Same herePhotos didn’t load?
Not really clipping unless i could get something of value for the "clipped" portion!The correct and proper term for this is "clipping".
https://en.wikipedia.org/wiki/Methods_of_coin_debasement#Clipping
View attachment 797412
View attachment 797419
HmmmClient #1 results
Stage 1 Conditioned: From no stand on edge to about 30% Stand on edge. little noticeable size change in mixed stack.
Original Condition 1-10 was a 5+/- End Condition 6 - 6.5
Stage 2 Conditioning: Still Flea bites but reduced sizes and sharper edges. Mixed stack, small variation to untouched and can be minimally felt. All conditioned chips are the same size as the equipment assures that.
Is it possible to look at the material you have removed? Just to get a feel for how “true” compares to the original.Better photo angle on the finished product, showing the edges? Tough to tell on that bottom photo.
What does it mean if I didn’t need to?Anyone else immediately google it?
Probably that we should be friendsWhat does it mean if I didn’t need to?
I can't even bring myself to finish cleaning and oiling a rack and I come across this mystical sorcery.Y’all are doing this stuff, and I’m too lazy to clean and flatten chips.