Barrington poker table thread (42 Viewers)

[PokerDogDoc]

Thanks @idkWhenToFold , that’s one suggestion I can consider, and I’m not opposed to doing some “reupholstering” work in the rails if it comes down to that.

If possible, I’d prefer to go even simpler and maybe find some sort of “cap” or “lid” I can put on/over the top of each cup holder. Maybe something that snaps in place? I think I’ll have to break out my ruler and take measurements and then do some trial or error.

Anyone else have additional ideas or suggestions?

 

[TwinChameleon]

3D printing a cap is probably the most sleek.

You could also just glue leather coasters to the top of foam cylinders cut to sit flush and put em in the cup holders. Mileage may vary on how that looks.

 

[PokerDogDoc]

Thanks @TwinChameleon , those are both good suggestions. I don’t have access to a 3d printer but I can find someone who does… Or maybe someone here on the forum?

I’m also digging the “capped insert” idea as an another, simpler, solution.

 

[TwinChameleon]

if i decide not to install deeper cup holders in mine, I may ask my friend to 3d model caps. If so, I’ll share it here.

 

[extreme517]

I'm interested in caps of some sort if anyone comes up with an option!