Building a 60” round - does anyone know where to source HD rail foam in a big enough sheet? Would prefer to avoid piecing together.
60” round - HD foam (3 Viewers)
- Thread starter JeepologyOffroad
- Start date
doughboy63
Flush
I haven't built a tables in ages, but I vaguely recall there was a trick to cutting a slit in the middle of the foam and you could stretch it to make it work? That very well could have been for the vinyl though, not the foam. Probably not helpful, sorry.
That works for the vinyl, not the foam.
https://www.pokerchipforum.com/threads/54-inch-round-table-build-question.35874/post-659591
I've always used a seam for 60s:
OP
OP
Can anything be done to hide the seam?
drdr
Flush
Didn't have the cash to buy a large foam sheet when built the first table. Used offcuts so had many separate pieces. I found that if the edges are pushed up against each other, bit under pressure, that no seam was visible through the vinyl. Took finessing. But a disclaimer; result may depend on the exact materials.
sonofneeway
High Hand
I have built 100+ custom poker tables and I always just cut a strip the width of the rail and wrap the foam around. I just glue the ends together if I need to use more than one piece and I have never had anyone complain about feeling a seam under the whisper soft vinyl. This way you can get several tables out of a single sheet of foam.
Create an account or login to comment
You must be a member in order to leave a comment
Create account
Create an account and join our community. It's easy!
Log in
Already have an account? Log in here.