stevea
Two Pair
I need 1/2” trim and 3/4” trim for the ply inside and outside. Probably 20+’ inside and 25+’outside. Thickness of material? Can I email you?I sell that too. Just let me know how much of it you need.
I need 1/2” trim and 3/4” trim for the ply inside and outside. Probably 20+’ inside and 25+’outside. Thickness of material? Can I email you?I sell that too. Just let me know how much of it you need.
...wouldn't it would look better with a padded rail?
Got a new railing installed this week for the mezzanine. I put up the old one as a temp railing which was just 2x4's with construction screws and some 45 degree braces. This one's 6x4 posts with 2x4's in between and stained. I wish I could take credit for this nice looking rail but this was hired work. The middle section will be removable with our forklift so it's not properly aligned yet.
View attachment 165644 View attachment 165645
Atleast your players can run the board out 5-6xI see Oval and Circular tables being built...but this 20' x 1' seems odd? Just hope the dealer isn't located on the far end, I'd need super JUMBO numbers on the cards to see the farrrrrr end.
Really need some poly on the posts. Kind of dull.
Serious question, how much sawdust have you inhaled over your lifetime? You could probably cough up a table at this point!Yes, it screws right to the bed so there's no chance of the whole staircase falling over or a gap forming between the bed and the stairs.
I'm not one to talk. My garage has a pretty constant 1/4" of sawdust/grass clippings/dirt in it. My wife doesn't even go out there anymore.I don't know what you're talking about. Our shop is like a surgical lab, absolutely spotless...
I wear a dust mask most of the time. We have a few dust collectors around the shop but there are some tools which don't hook up to the dust collectors and kick up a LOT of sawdust. I think earlier that day we were using a 1/2" router tracing some templates. I'm swimming in sawdust by the end of the day.
Yep, people just have to bring their charging cables so that they can plug into the USB 3.0 ports. I just had someone else place an order last week wanting the same thing for their 10 player table.
View attachment 180668
Looks jus as good as the one I gotI got some new gaming suede that I'm testing out. This is gaming suede #6 (the last 5 have not been up to my standards).
So far so good, I'm hosting tomorrow night and I'm going to be breaking it in and will be playing on it all night (unless I bust early). I tried pitching some cards and low power and it looks promising. It has a slightly higher nap than my current fabric but is very reasonable. The other side of the fabric is actually much fuzzier so I printed on the less fuzzy side. I can flick much harder than shown in the video, it's a medium flick/push that I'm doing.