lighted raised rail table // how to // PART 1 (1 Viewer)

meatboy

High Hand
Joined
Nov 9, 2014
Messages
70
Reaction score
106
Location
germany
I think i might be useful to post this howto also over here :)

it's just a small tutorial of how to build a raised rail poker table...


:)


Here are the plans / profiles (all units in centimeters):


table.jpg



querschnittrr_bel_3.jpg



I have used three sheets of wood. One for the base, one for the playing surface and one for the rail and the raiser (same coloured parts in the profile are from one sheet)


Lets getting started:


1st is to route the rail. I have used 12mm OSB board (similar to ply but lighter and stronger). I have routed the circular parts and cutted the straight parts with my circular saw and jig saw.


DSCF0118.jpg



DSCF0119.jpg



DSCF0120.jpg



DSCF0121.jpg



DSCF0123.jpg



DSCF0124.jpg



DSCF0128.jpg



done :)


i have used the cut out to make the 4cm hight raiser blocks.


DSCF0127.jpg



1st cut into the playing surface board to get the outer rail lid (the small part that will be attached under the rail)


DSCF0133.jpg



assembling the rail (the white hartboard is to attach the LED strip):


DSCF0140.jpg



DSCF0141.jpg



DSCF0142.jpg
 
Can you repost the first pic please? It has been blacked out.
 
LED attaches to hart board? Are you using a defuser?
 

Create an account or login to comment

You must be a member in order to leave a comment

Create account

Create an account and join our community. It's easy!

Log in

Already have an account? Log in here.

Back
Top Bottom