Here is a DIY conversion I did of my racetrack table today.
Inspired from a post that k9dr posted
Took the rail off, then I used two layers of cardboard with duck tape to level out the racetrack
Put some HD foam on top, cut it to fit, then used 77 adheasive spray to connect hd foam to table.
Put rail back on the make sure it still fit
Put felt on and made sure it was even then used 77 adheasive on the felt
I followed Chanmans Video guide except I stapled to the side of the table so that I wasnt stapling into cardboard
After I was done there was some some wide spaces under the rail at the ends of the table and was getting alot of hangers, so I just wedged some cardboard in there and works like a charm
Thanks for the resources in this forum. And thanks k9dr for the help
Inspired from a post that k9dr posted
Took the rail off, then I used two layers of cardboard with duck tape to level out the racetrack
Put some HD foam on top, cut it to fit, then used 77 adheasive spray to connect hd foam to table.
Put rail back on the make sure it still fit
Put felt on and made sure it was even then used 77 adheasive on the felt
I followed Chanmans Video guide except I stapled to the side of the table so that I wasnt stapling into cardboard
After I was done there was some some wide spaces under the rail at the ends of the table and was getting alot of hangers, so I just wedged some cardboard in there and works like a charm
Thanks for the resources in this forum. And thanks k9dr for the help