Practical ( Inlay / Hot Stamp ) Design question. (1 Viewer)

[Erich Wise]

Can one do a single (shaped) inlay (one side) and a hot steam on the other side of the same chip?
If there are problems with this what are they? (If you just think it would e ugly that's fine I'm interested in hearing that too.
If not, are there any examples?

 

[FordPickup92]

I would assume that could potentially cause some warping... not sure I've ever seen a dual sided chip....
@BGinGA
@RichMahogany
??????

 

[kmccormick100]

Somebody did these and they were killer, I wanna say a suicide queen set? Lemme go try and find em

 

[FordPickup92]

Somebody did these and they were killer, I wanna say a suicide queen set? Lemme go try and find em

Ohh you might be right... think I have a few of them!

 

[FordPickup92]

@kmccormick100, these?

 

[BGinGA]

Somebody did these and they were killer, I wanna say a suicide queen set? Lemme go try and find em

I recall some discussion of relabeling one side (monogram) of an existing hot-stamped chip -- and keeping the denom side as-is. Don't know if they actually did it, though.

 

[kmccormick100]

@kmccormick100, these?

View attachment 380503

Nevermind. Hotstamp fracs and similar looking inlays