3D printed buttons (1 Viewer)

[Goosefraba]

made some simple NIT buttons and also found an All In button design online. If I print them again I might add some more thickness to both more so for weight but I would like for the All in button to stand on it own.

Not sure how they’ll slide on the felt but they’ll get the job done

 

[EastCoastCali]

Is the NIT lettering extruded or indented? Almost looks like it’s raised off the surface from the pic.

 

[Goosefraba]

Is the NIT lettering extruded or indented? Almost looks like it’s raised off the surface from the pic.

Yes, the letters are raised a bit

 

[chestateegold]

I've been looking for a better all in button. I never thought about 3d printing them. I'll have to check it out now.

 

[Goosefraba]

I've been looking for a better all in button. I never thought about 3d printing them. I'll have to check it out now.

This one took a few tries because I initially wanted it on a smooth plate that would transfer a carbon fiber pattern but I couldn’t get good print bed adhesion and the print would mess up after a few layers. I tried cleaning the plate and using a glue stick but I had to switch back to the textured plate bc I didn’t want to waste filament over and over. I’m satisfied for the time being with the textured one.

 

[Goosefraba]

My take on a racker stacker. The group I play with does 50 chip starting stacks. Thought this would be fun to have out pregame as stacks are being distributed.