Bought a Drill Press..What king of Bit for 7/8" Label ?? (1 Viewer)

[RussB42]

What type of drill bit do I get to do 7/8' labels?

 

[AK Chip]

Bottom cleaning router. I haven't used it yet so cannot say 100% that I'm right. But it should work.

 

[Psypher1000]

Bottom cleaning router. I haven't used it yet so cannot say 100% that I'm right. But it should work.

This is correct. You want a 23mm bit if memory serves, though, not a 7/8" bit. It's either 23 or 27mm. Can't remember off hand. I will check when I get home.

 

[Psypher1000]

This is correct. You want a 23mm bit if memory serves, though, not a 7/8" bit. It's either 23 or 27mm. Can't remember off hand. I will check when I get home.

I lied. It *is* a 7/8" bit you want.

 

[RussB42]

Ok thanks,

 

[Random Phish]

What about a 1" label? A 1" bit?

 

[RussB42]

Just trying to keep all the Inlays and labels the same size.

 

[TheBigTater]

Can I ask what kind of Drill Press you bought Russ? I'm starting to think of jumping in on a drill press for milling purposes (even as poorly mechanically inclined I am with power tools).

I can still play poker with 4 1/2 fingers right?

 

[BUBBLE]

Can I ask what kind of Drill Press you bought Russ? I'm starting to think of jumping in on a drill press for milling purposes (even as poorly mechanically inclined I am with power tools).

I can still play poker with 4 1/2 fingers right?

Possible but your chip shuffling may suffer

 

[RussB42]

It's a WEN Mod 4208, got on Amazon for Less than $80.

Still in the Box, as I haven't had time to try it out.

 

[TheBigTater]

Thanks Russ I'll add it to my searches. Figured for the prices I've seen and if the lower powered/speed units will work for milling it's not that big an investment.

 

[RussB42]

Your Welcome,,,

I just hope I can check it out fairly soon..

 

[i'm nobody]

I was fooling around with a bench mounted drill press for practising before I start milling chips and I discovered one thing. Set your speed to the lowest setting and ensure your fixture you are putting your hip into holds it fast. Good luck.

 

[RussB42]

I've been down with my COPD for a couple weeks and then got Strep Throat... Haven't even unpacked my Drill yet.

 

[dew4au]

I've been down with my COPD for a couple weeks and then got Strep Throat... Haven't even unpacked my Drill yet.

Sorry to hear that, Russ! I hope you can pull through it soon.