Sold Flamingo $5 Labels - 400 (1 Viewer)

I purchased these labels from @Gear in November with the intention of using them for two racks of yellow solids I had acquired. Unfortunately, the racks didn’t match the ones I had on hand, so I had to let them go. From what I’ve heard, these labels may shrink slightly if left on the sheet for too long, so I’d much rather see them put to good use than go to waste. I’m offering these at a steep discount compared to what I originally paid—my loss is your gain. Detailed information is provided below. As many of you know, @Gear includes extras with their labels to account for any potential production flaws or mistakes during application.

400 x Flamingo, Reno NV $5 (200 chips)
* target chip: Paulson TH&C, milled
* sized for: 7/8" nominal (Josh Kifer)
* laminate type: Smooth

Price: $50 shipped

 

[Pippa]

Fratello
Show the chips!!!!!!!!

 

[tallsbutler]

I am interested. Will these work with a murdered THC? Or only a milled THC from @Josh Kifer?

I measured the murdered THC I have and they seem like they are right on 7/8 for the opening. Concerned if these labels are exactly 7/8 they'll be too snug.

Could either you or @Josh Kifer advise? Thanks!!

 

[horseshoez]

I am interested. Will these work with a murdered THC? Or only a milled THC from @Josh Kifer?

I measured the murdered THC I have and they seem like they are right on 7/8 for the opening. Concerned if these labels are exactly 7/8 they'll be too snug.

Could either you or @Josh Kifer advise? Thanks!!

I'm not sure actually. I've never tried using labels that were made for milled chips on murdered chips. I'll let Kifer answer that question so I don't put my foot in my mouth lol

 

[Josh Kifer]

I am interested. Will these work with a murdered THC? Or only a milled THC from @Josh Kifer?

I measured the murdered THC I have and they seem like they are right on 7/8 for the opening. Concerned if these labels are exactly 7/8 they'll be too snug.

Could either you or @Josh Kifer advise? Thanks!!

7/8 should fit most milled chips. Murdered it might be a hint small of an opening. Really depends on what Gear set the sizing at when he made em. @Gear ?

 

[Josh Kifer]

But I can say Milled, should fit from my experience.

 

[NotRealNameNoSir]

I am interested. Will these work with a murdered THC? Or only a milled THC from @Josh Kifer?

I measured the murdered THC I have and they seem like they are right on 7/8 for the opening. Concerned if these labels are exactly 7/8 they'll be too snug.

Could either you or @Josh Kifer advise? Thanks!!

Please buy these, good deal and I'll otherwise buy them just to put over my own $5 labels to make them more flush.

 

[Saditsfact]

Please buy these, good deal and I'll otherwise buy them just to put over my own $5 labels to make them more flush.

 

[CDC]

I'll take them if they are still available!

 

[tallsbutler]

I'll take them if they are still available!

You got em @CDC

I never dibs’d, was just exploring the idea.

All yours.

Thanks for the replies all!