My plan this year is to design and produce a custom tourney set. The inlay design is still up in the air, but I started playing with the chip design tool to come up with colors and spot progression. This is the first set, after dozens of attempts, that I kinda like. T25, T100, T500, T1000, T5000, and T25000. Not sure if I would do a full six denoms, but did them all for completeness. I did shaped inlays in this design but not sure if it will make the final cut, but it looks cool. Any and all comments or suggestions, both positive and negative, are welcome.
Option 1. All dual spots.
Option 2. Swap between dual spots and single spots
Trying to keep all chips to 3 colors, base and two spot colors ( except the grey (T100) in option 2 ).
I think for the most part the set looks good, but the blue (T5000) chip kinda feels out of place when I look at the entire set together. Especially in option 2, the grey and blue chips sorta look too similar. I also mocked up an orange chip to replace the blue.
I'm just afraid that the orange and pink next to each other are too close?
Anyway, have at it and let me know what y'all think. Thanks.
Option 1. All dual spots.
Option 2. Swap between dual spots and single spots
Trying to keep all chips to 3 colors, base and two spot colors ( except the grey (T100) in option 2 ).
I think for the most part the set looks good, but the blue (T5000) chip kinda feels out of place when I look at the entire set together. Especially in option 2, the grey and blue chips sorta look too similar. I also mocked up an orange chip to replace the blue.
I'm just afraid that the orange and pink next to each other are too close?
Anyway, have at it and let me know what y'all think. Thanks.