Sure. I will add pics later, am done for the night. Worked wonders on the Para-A-Dice too! I am stoked.
Disclaimer - I do not know if there are any long term issues with this process. I am only starting with 4 chips to see how it goes.
1. Cut down the middle of the inlay with a sharp knife at a 90 degree angle to cut into the plastic covering of the inlay. (I used a box cutter) Peal up an edge of the plastic
2. Cut a smaller cut in the middle to make another edge.
3. Pull up on the plastic, but do it slowly so that it pulls up on the paper underneath as it comes up (to help loosen it).
4. The plastic comes off pretty easily.
5. Put 3 drops of non-acetone nail polish remover on the paper, you will see it darken as it gets wet. This is the step I am not sure of. I used this to remove cancellation stamps from chips and it seemed to work ok. It does dry the chip out, I washed the chip with soap and water after. I will oil after I put new labels on.
6. Pull the paper label off in one peice, it slides right off.
Walla!
