So I had this idea to counter the concaved shape of the scrown face. The outer edge of the die touches the chip first so to get the center of the die to touch the chip the edges stamp to deep for consistent stamps. My idea is to stamp the same side of the chip twice, I have no idea if this will work or not. It will take a lot of patience to get the chips to line up right but I think I can do it with a little set up time.
I'm going to try doing this on the A-Mold for my personal set but if the chip will stand up to the double stamping it could be a solution to stamping the Scrown and lcrown chips.
For the A-mold denom side I will just use one die and stamp it once. For the swoop side I will use the two dies to make the stamp(seen below on the green scrown)
I will use silver foil for the text but will use the holographic foil to create the aurora on the chip. I hope this will work!!
Thanks @Johnny5 !!!
I'm going to try doing this on the A-Mold for my personal set but if the chip will stand up to the double stamping it could be a solution to stamping the Scrown and lcrown chips.
For the A-mold denom side I will just use one die and stamp it once. For the swoop side I will use the two dies to make the stamp(seen below on the green scrown)
I will use silver foil for the text but will use the holographic foil to create the aurora on the chip. I hope this will work!!
Thanks @Johnny5 !!!