PocketQuads
Sitting Out
Hi there,
I am planning on creating a custom chipset which would be used more as promotional material rather than as actual playing chips. I want each individual chip to have sort of like a "serial number" on it (e.g. #1 - #100), so that they have the same general design, but are still uniquely identifiable.
I emailed CPC if something like this was possible with them, and unfortunately they can neither offer this, nor create their chips without an inlay (so that they could be added later) because they use compression molding instead of injection molding.
So my question now is: How would you do something like this? Are there any comparable custom chip vendors that would allow something like this? Or is it possible to order the chips with a random inlay from CPC and then somehow swap that out later?
Any help or hints in the right direction would be much appreciated
I am planning on creating a custom chipset which would be used more as promotional material rather than as actual playing chips. I want each individual chip to have sort of like a "serial number" on it (e.g. #1 - #100), so that they have the same general design, but are still uniquely identifiable.
I emailed CPC if something like this was possible with them, and unfortunately they can neither offer this, nor create their chips without an inlay (so that they could be added later) because they use compression molding instead of injection molding.
So my question now is: How would you do something like this? Are there any comparable custom chip vendors that would allow something like this? Or is it possible to order the chips with a random inlay from CPC and then somehow swap that out later?
Any help or hints in the right direction would be much appreciated
Last edited: