aaronroch
3 of a Kind
Oh- almost forgot. Get a small set of plastic clay modeling tools. Sometimes, due to user error (or if labeling China clays, production variances) the label will be off by just a hair or be a hair too big. Removing and re-sticking is preferred, but what if the label is too big? With these puppies you can smooth out the label right into the corner of he chip recess and right up the wall of the recess! If you are only off by a hair this is fast, easy and looks indistinguishable from perfect chips when done.
It will take a little trial and error to figure out “how close” is close enough to pull that trick. It I’m sure you’re ordering a few extra labels anyway.
https://www.amazon.com.au/Creativit...odeling+tools&qid=1566215604&s=gateway&sr=8-5
It will take a little trial and error to figure out “how close” is close enough to pull that trick. It I’m sure you’re ordering a few extra labels anyway.
https://www.amazon.com.au/Creativit...odeling+tools&qid=1566215604&s=gateway&sr=8-5