7/8 circle hole punch recommendations. (2 Viewers)

[Monstercash]

Looking for recommendations on a good 7/8 circle hole punch to use to cut out custom poker chip labels made via inkjet printer and printed on adhesive matte paper. I bought one on Amazon and it started getting dull after making 40 punches.

Thanks!

This is the one I bought. Junk.

 

[Sunshine]

You could get pre-cut ones from onlinelabels. Here are round 7/8. You can pick material and sheet number with the options on the right. Alignment and printer feed can be a little tricky, though, depending on the quality of your printer.

 

[pkrchp]

Efco Punch M Circle 7/8 Inch
I’ve only used a smaller one, but it works quite fine. (For reviews look at .co.uk or .de)

Try punching aluminium foil (no kidding) to sharpen the punch you have.

 

[Darson]

I did the same thing then bought pre-cut labels as @Sunshine suggests. Much easier although it takes a little time and lots of wasted sheets to get the alignment correct.

 

[allforcharity]

Try punching aluminium foil (no kidding) to sharpen the punch you have.

Ingenious! You learn something every day!